This product will inhibit spoilage microbial growth in water.
FOR CONTINUOUS TREATMENT TO INHIBIT THE RE-ESTABLISHMENT OF SLIME, ALGAE, AND BACTERIA AT A CONCENTRATION OF 3.0 PPM
- Activate GC 30 according to "Directions for Use" on product label.
- Using a dosing pump, add activated GC 30 to watering system until water reaches a concentration of 3.0 ppm (required concentration levels vary according to site-specific conditions—monitor the microbial content of the water and increase or decrease the addition rate of the activated solution as needed); [higher chlorine dioxide injection rates, such as 3.0 ppm can ensure chlorine dioxide residual of up to 0.8 ppm is sufficient to provide adequate treatment. Residual disinfectant and disinfection byproducts must be monitored as required by the National Primary Drinking Water Regulations (40 CFR Part 141) and state drinking water standards.
- Dispose of package(s) and spent envelope(s) according to instructions on package label. Do not reuse.
NOTE: Use ultra-low-range Gard'nClean® Chlorine Dioxide Test Strips to verify concentration at downstream production points. Organic loads vary across water supplies, and will influence injection level necessary to ensure 3.0 ppm concentrations at emitter hoses, mist nozzles, drip tubes, and other point-of-application.
FOR CONTINUOUS TREATMENT TO INHIBIT THE RE-ESTABLISHMENT OF SLIME, ALGAE, AND BACTERIA AT A CONCENTRATION OF 0.8 PPM
- Activate GC 30 according to "Directions for Use" on product label.
- Using a dosing pump, add activated GC 30 to watering system until water reaches a concentration of 0.8 ppm (required concentration levels vary according to site-specific conditions—monitor the microbial content of the water and increase or decrease the addition rate of the activated solution as needed); residual disinfectant and disinfection byproducts must be monitored as required by the National Primary Drinking Water Regulations (40 CFR Part 141) and state drinking water standards.
- Dispose of package(s) and spent envelope(s) according to instructions on package label. Do not reuse.
NOTE: Use ultra-low-range Gard'nClean® Chlorine Dioxide Test Strips to verify concentration at downstream production points. Organic loads vary across water supplies, and will influence injection level necessary to ensure 0.8 ppm concentrations at emitter hoses, mist nozzles, drip tubes, and other point-of-application.
For more information please reach out to a Gard'nClean Advisor at hello@gardnclean.com or 888-369-1975.